Bruce Jones Surfboards Inc.
16927 Pacific Coast Hwy. Sunset Beach, CA 90742
(562) 592-2314 (714) 840-6500 Fax (562) 592-9614
TOLL FREE (888) 592 2314
Internet: brucejones@brucejones.com
If you have chosen a board from our inventory listing page, you can go to our Direct E-mail Order Form ,or our Order Form ,and fax or mail it back to us. Or you can call, e-mail or fax us with the board number, your name, address and phone number, and we will get back to you concerning the details of shipping and payment, and we will answer any questions you might have! Thank You!
Name - please print clearly
as your name is inked on the board near the serial number.
Date address etc. - just fill in.
Previous experience - beginner, advanced or how many years
of surfing.
Shaping - the style of board, i.e., high performance
thruster, hybrid, longboard, or any combination that makes sense.
Length - the bottom measured length (waterline length) of
the board, which is the convention. If you prefer a deck measured
length, please indicate under shaping comments.
Width - maximum width measured at the widest part of the
outline, usually near center.
Thickness - maximum thickness at the thickest part of the
board, usually near center.
Nose and Tail - the width of the outline measured 12"
from each end.
Tail shape - the actual outline shape of the tail, i.e.,
square, squash, rounded pin, etc.
Deck contours - the width-wise shape of the deck, i.e.,
flat, semi-flat, domed or semi-domed.
Bottom contours - the width-wise shape of the bottom,
i.e., flat to v, flat to concave v, concave nose to flat to v,
etc.
Rails - the profile of the rail as viewed in a cross
section, i.e., thin and tapered, full and not tapered, or any
description that makes sense - we can figure it out!
Blank - the density of the Clark Foam blank, i.e.,
ultra-light, superlight, superblue, or supergreen. The order is
from lightest and weakest, to heaviest and strongest. (Blue and
Green are code names - the foam is white!).
Stringers - the center and/or offset wood stringers going
lengthwise down and through the blank. The default is 1/8"
to 1/4" spruce, depending on the length of the board. Two
1/8" spruce glued together down the center is the best, as
this creates a plywood like effect, giving more strength than a
single piece of the same width.
Typical use - where the board is going to be surfed most,
i.e., a gentle reef break, a more hollow beach break, or the
North Shore for example.
Shaping Comments - anything you would like to get across
to Bruce to help him shape a board best suited for you!
Graphics - describe the color design you have in mind in
your own words, the draw it on the order form or on a separate
sheet.
Lamination - strong, average, light, or very light.
Remember, stronger boards are heavier, our standard glass jobs
are stronger than most!
Labels - describe which labels and their color, and draw
where you would like them placed on the board.
Fins/boxes - describe what type of fin set up you would
like, i.e., three glassed-on thrusters, a center fin box with two
glassed-on side fins, a center box with two O’fish’l
side boxes, or any set-up you would like.
Pinlines - any black lines going around and highlighting
your art work.
Special instructions - mainly for the finish of the board
, either a sanded finish, or glossed and polished (two more
steps).
Customer approval - sign here to indicate that the order
is as you wish.
Date due - indicate when you would like the board. The
default minimum is three weeks for boards with no or simple art
work.